Search results

It possible InkEnd sensor damaged on some cartridgeholder. And this sensor is erased smartcard.

Originally it looks as on attached pictures. But in my opinion the construction of this cut sheet option is not good because: - cut knife is lose sharpness very quick and not cut the media completely; - same marzan is used for knife (even if another line); I think will be better to use manual...

This problem can be caused by poor contact on long flat cable connector. On mainboard or carriage board. Try to reconnect cables.

Menu Cleaning -> Initial Ink Charge will recharge ink lines

Best solution will be write new profile. For best result on 720x1080 resolution is use variable dot family (VSD3), Interlace pass 2, and Fine and Fog 3 wave.

Network disconnecting can be caused of wrong network setings and collision in network. For example, if you use two network connections (LAN and WiFi) and both in same submet. First of all for check you have to switch off WiFi and connect your printer directly to LAN connector on PC and test.

It is possible somethigng happened with flash memory of printer and parameters was resetted to default. And maybe serial number was erased in memory. It can be reason what printer not accept smartcards. First of all you have to check if serial number is correct in diagnostic menu. And maybe...

First, you have to check head cable. It can be short in pins. And it possible power transistor is blown too and need to replace.

I think first of all need to check state of reduction belt. It can be damaged or missed some tooth.

I found photo with OEM Mutoh printhead (with green connector) and F186000 together. You can see a difference in level of manifold front side...

Yes, it possible. But in my opinion it is not good idea - to install old (maybe glogged) manifold on to new printhead.

Epson F186000 printhead have a little bigger front side of manifold. For install this printhead in Mutoh printher you have to cut a little head fixer frame. And Head Rank have another format, so you can't write it in printer's HeadRank menu.

Actually, if smartcard is working, only smartcard position is important. Please look at the picture for check if your cards mounted correctly.

This error just informed you about printhead warranty lifetime - 6 billion fires. This error will shows untill you reset a counter in maintenance menu. The counter will not reset automatically even if you will install new printhead. For reset this message you have to go in maintenance menu and...

I know who can help you. Sent info in PM

I am not sure you will foud refillable cartridges intread OEM bags. You can directly connect tank for ink with ink inlet. I think it will be best solution. But first of all you have to unlock the printer for use third party ink. I am unlocked my 1614 and 1624 printer but use refillable cartridges.

F2 fuse is 750 mA http://www.signs101.com/forums/showthread.php?130199-What-next-Mutoh-print-issue-need-advice-please&p=1277374#post1277374

Best solution will be unlock the printer If you use third party ink or chip reader sensor is damaged.

Yes. if printhead not printing completely. Not printing any nozzle. Than fuse can blown. Most cases it is F2 fuse on mainboard.

What ink you used? I think not original if you installed resettable cartridge. Problem can happen if you mix non-orginal ink and original cleaning solution.