Search results

What is IP setting for WiFi on your notebook? If DHCP then please check your IP for WiFi is not in same range as LAN port for direct connection to the printer.

It is maybe too high static on media. And air humidity is too low.

It is not Mutoh format of head rank. Heads from Mutoh has 24 symbols on the rank,

It is not 100% necessary, but extremaly recommended. Prithead will work with wrong head rank but in wrong mode.

Try to remove all cartridges a little and switch ON the printer. If same E9 error will display - you will need install and activate new SIM-card. Sometimes it may happen if you downgrade or change manufacture code of the printer.

Officially Mutoh and Xerox does not make a conversion to each other. But I saw the Xerox printer what worked with Mutoh cartridges and it was unlocked completely after some time. So, it is possible. The difference in some parameters or printer's memory. Hardwares are the same.

Check the needle what going into the cartridge. It can be clogged.

The question about unlock has been covered in the topic by link: https://signs101.com/threads/mutoh-valuejet-1324-kcmy-broken-chip-error.138619/

VJ1324 printers has a big probblem in ink line. It is valve between cartridges and dampers. One time it stops to work correctly and do not open fully as it needed. So, check the valves or open it temporary by hands.

All cards are different. Depend on ink type and colour. It is impossible to use card from other colours on K colour.

It is demo mode of your SAi Photoprint.

The unlock procedure is uploading special service code to printer's memory. That code is switch off module of smart card detection. The code is unique for each printer. But normally Mutoh does not provide unlock to customers. So, you have to ask some technician for create unlock code if you need...

It maybe one Magenta ink line is clogged. Or filled by air with subtank together. Each ink line on 1638 printer splits on two printheads.

No. I think your cap in good condition. But your maintenance station had a rest of ink in pump tubes. These ink goes to waste tank and created siphon effect. Because If air leaking was between cap and printhead it can't cause ink flow from ink bottle to waste tank. For prevent it in future you...

I sent you message with contact

How your printer does connectet to PC? Directly or with HUB? Please check network setting. It can be caused by collision.

No image in your post

Answered in PM

What smart cards you use for load to the printer? Actually, 24h request for CR Maintenance happened on 1638X starts from firmware 3.08 if you use UMS smart cards. You can find this information in corresponding technical bulletin from Mutoh. You can use EMS smart cards and never see request for...

Yes, it possible. You can contact with technician via email geshkin@ukr.net