Search results

Good info... Thanks

I swapped the cyan head with the yellow to get by ... the overspray issue is much less noticeable on yellow. Before I did that I cleaned up the head by soaking and pulling solvent through - that reduces the overspray but wont fix it fully

I swapped the cyan head with the yellow to get by ... the overspray issue is much less noticeable on yellow. Before I did that I cleaned up the head by soaking and pulling solvent through - that reduces the overspray but wont fix it fully

That looks bleak... Soak em overnight and try nozzle test again... what's the supplier saying.?

I knackered a head (dx4) on my Mimaki. Messing about cleaning I got solvent on the Ribbon Cable which ran down to the head board. Nozzle print started to fade more and more until nothing.... sounds like you might have done the same

I have that cutter.. I don't have any trouble with the quality on heat transfer material - prob just need a new blade. The problems I usually get with the Mutoh is when it decides not to read the reg marks (bad epos)

Service manual with all the alignment procedures here... http://www.signs101.com/forums/showthread.php?91846-Mimaki-JV3-160SP-collection-of-PDFs-amp-Tutorials-in-one-place ...give your encoder strip a clean first though.....

Encoder Strip - Mine was banding like that once, and it was a blob of cyan on the encoder strip. Worth a try first anyway...

Any Ideas.?

Its looking like it's the Slider Board. I swapped magenta and cyan over at the slider board and the overspray issue moved to the Magenta head. It's just odd that after printing about 300mm of overspray the head starts working perfectly. And then runs fine all day...? Thanks Mike for the help...

More weirdness........ Switched the printer on about 3 hrs ago and left it innactive. Just tried the same test print and the Overspray is massively reduced...?

I fitted a new Cyan head about 6 weeks ago. Alignment etc all seems good. The new head printed sharp and strong immediately. Somewhere in the last few weeks I've been getting overspray from the Cyan head - Only when I first turn the printer on - (but the nozzle print is perfect) If I run a few...

have you tried swapping the magenta data cables over to see if the right side of the head works ?

Bump......

Ok so turns out they're the same apparently....next question: The new heads have no ID on them.... The seller says it's not a problem Can I just enter the Head ID from the old Head I am taking out.?

Hi, Got a chance at some cheapish second hand heads. I'm on full Solvent ink, but these are down on the invoice as Eco Solvent Heads (DX4)-(M004372) Are they the same part..? Sorry if this Question has already been answered a thousand times on here...

Hi, can someone post a link to a user manual for Onyx Postershop 7 Thanks

Roland GX24 - Sits on a desktop taking up no room - Cuts straight from Illustrator - Cheap Second Hand - does a nice Job

Best I can do is Republica Condensed.

I didn't realise there was a whole Maintenance Manual available, I had only looked at the Service Manual. Got it from here.. http://www.signs101.com/forums/showt...s-in-one-place Thank You "GetCustomized" - I ran the alignment procedures and it worked!:omg: - Now to sort that overspray issue