• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. Discussion Dampers: original vs. generic

    It depends on volume of work, but the average is 18 month

  3. Discussion Dampers: original vs. generic

    Have 3 units 1624, only used original dampers, never used generic. Original dampers had the same life as printheads, so when ever I replace a printhead, I replace the dampers, cables & capping station as well. This combination never fails.

  4. Bypass auto cleaning

    You can't turn it off completely, but you can adjust the settings to the minimum.

  5. Software Question.

    Wasatch

  6. Question How do you make a transmissive profile for a clear film when it has permanent adhesive and an opaque backer?

    Totally agree with you, this is only because of the limitation that we don't have a transmissive SPM

  7. Question How do you make a transmissive profile for a clear film when it has permanent adhesive and an opaque backer?

    As I don't own a transmissive SPM, I create a profile as a reflective material then print using 2 strike mode, it works fine for clear media, for translucent media I have to reduce the ink limit a little bit.

  8. Mutoh Printhead

    www.solventinkjet.com
  9.

    Printing problems

    This is probably ink cluttering due to media not able to hold that amount of ink, high speed printing or platen temp too low.

  10. large mural prints not tiling accurately

    That is a common problem with Latex and Z serious, happens because of the OMAS module. Sorry to say that but the only solution is to stop the optical media advance sensor OMAS. If you are using RIP like Caldera, there is an option to disable OMAS, in this case you will get consistent results but...

  11. Backlit media fast dry methods

    Exactly, we used to do that 20 years ago, you reminded me of the good old days.

  12. Backlit media fast dry methods

    Extra wait time between passes will make the print speed super slow, increasing the temp above normal limits will cause the ink to loose it's vibrancy.

  13. Backlit media fast dry methods

    With all respect to increasing temp and wait times between passes, I have experimented all of these and nothing will work, search for good quality media like HP or Natura.

  14. Backlit media fast dry methods

    It seems that the media isn't of good quality.

  15. Need Help Y OVERCURRENT ERROR

    I'm not familiar with Mimaki's but I got this error several time on Mutoh 1624. It was always due to dust on encoder strip, vanishes once cleaned.

  16. How run compatible ink L26500?

    Then the chip is defective and the cartridge needs to be replaced by the supplier

  17. How run compatible ink L26500?

    Most Latex compatible ink suppliers, supply pre filled cartridges with fresh chips. So what you have to do is simply plug and play unless the supplier instructs otherwise.

  18. Need Help [Need Supplier] Digital Printing and SAV Installation in Doha, Qatar

    Sure we can. If you can grant visa issues.

  19. Wall Mural vinyl recommendation

    Like Mike said, same approach here. What is good on a certain finish will not be good on another.

  20. Need Help Has Anyone Ever Tried This?

    Done it several times, but only when I a large tolerance is accepted. AS Pauly said, almost impossible to re align.

  21. Need Help Epson DX7 Heads and their various incarnations

    https://www.digiprint-supplies.com/en/vs-series-dx6-printhead-6701409010-pphrovs01
Top