Search results

iI can't see the dancer bar, that trips the sensor.

Do a medium cleaning having a set of cartridges in one position, then put the cartridges in the other position and do a couple (2-3) power cleanings.

Post a photo of the displayed error.

Do a "Sensor check" to see, if the switch is working.

The Roland Max3 has a very clean yellow (compared to Max and Max2). It also dries faster. Lately, I had some issues with Max3 yellow. I switched those (customers)machines back to Max2.

The Versaworks update won't change a thing. It's mostly because of newly introduced printers. Except your version is very old.

They are almost identical in terms of parts. So it will affect both, when HP decides to stop support.

Could be a faulty web wipe. A customer of mine once installed a L1500 web wipe into a R1000... gave him similar problems.

You need to do horizontal adjustment in service mode.

It's normal, that the heater is off by default in service mode. You can turn it on, if you want to.

What happens, if you use the "hotfolder method"? If this also fails, it's definitely a Onyx issue.

Very interesting and good to know.. Thank you.

There aren't many active components to go bad on the carriage boards on "pre Ricoh" Rolands. As far, as I remember it was a opamp that buffers the thermistor and the sensor. That said, it will likely be a transistor on the headboard, or in this case the main board. (by the way, the transistors...

Versaworks doesn't accept files, that are smaller than 1 inch.

On first sight, it looks like a feed problem. But then, there are no signs for it on the control print. I wonder, if it could be ink pressure related. The L630 (and new L700) don't use intermediate tanks anymore, so the pumps need to pulse all the time while printing to keep the ink pressure at...

Was it Max3 ink?

Could be a bug in Versaworks. Is it up to date?

Ah yes, it's called origin of course, not offset as I stated...

Do you have 41V on the head board?

Do a blade setting with offset, lateral and longitudinal. If the offset is off, it can chip the blade immediately. (Offset for tang. blades is not the same, as for drag blades. If it's off, the blade gets pushed through the medium at an angle. (Could happen if the small timing belt in the head...