Search results

Hi, just today I ran into a banding issue every few inches with my VJ1324. I run 3rd party inks and my nozzle checks are almost perfect. I just replaced my magenta cartridge and the black and yellow inks are getting low but it's not beeping at me to change them yet. Could it be time to change...

Hi, just today I ran into a banding issue every few inches with my VJ1324. I run 3rd party inks and my nozzle checks are almost perfect. I just replaced my magenta cartridge and the black and yellow inks are getting low but it's not beeping at me to change them yet. Could it be time to change...

Great, thank you for the advice. I'll stick with the 210 Lam

I was thinking maybe for race cars, since they get beat up anyways. Just don't want it to go to waste. But it may be the best to use the 210 Lam and save the 3420 for the short short term use. Thank you the input.

Hello, so I've almost gone through a roll of Arlon DPF4500 GLX and I have close to 1/4 roll of the Arlon 3420 Laminate left. I'm switching to Oracal 3165RA and the 210 Laminate for short term use stuff. Do you think I can get away with pairing the 3420 laminate and the 3165RA until the 3420 is...

Great! Thank you. I'll reduce the heat and turn the vacuum up and give that a try. I know I'm printing with the head height on low as well. I can give it a shot printing on high if I have to also. Thanks guys for all the advice!

Thank you, I did switch out material so I'll check all of that out more in depth. Thanks again!

Hello, this is my first post here. I bought a used Valuejet 1324 a couple months ago. It's printed great up until now. I always do a clean and a couple nozzle checks before printing. But for the last couple prints it has been leaving streaks. I did the CR Maintence as well and it's still leaving...

Thank you!

Does anyone know the name of this font?? Thank you!