Search results

I have a mimaki cutter cg-75fx that I am having problems with repeatability of cut. Will not cut in the same spot or even within .1 - .3 mils of the same spot twice in a row. Hardware looks flawless, low mileage cutter. I have the maintenance manual and am about to blank all the calibration...

Hi I have a couple of JV3 printers. One has V5.1 firmware installed and the other is V7.2. I have tried going through the mimaki website and searching only but I can't find a listing of the various firmware revisions that were issued by Mimaki and what issues they fix/address. Most...

I would like to use the parallel port on my JV3's instead of firewire. I went to the mimaki website and downloaded their Drivers 3.0 archive as these are guaranteed to work with win 7 32/64 bit, but there are only USB 1.1, USB 2.0 and Firewire Drivers. Where do I find a driver that will allow...

I want to put in a ventilation system for my JV3-130 printer that is running SS2 full solvent inks. Printer is intermittently used. I looked in the manual but can't seem to find any rough numbers about how many CFM of airflow will provide adequate ventilation for this printer. I intend to hook...

Again a newbie question.. I see a lot of references to changing the peristaltic ink pumps on these printers. What typically fails on these pumps? Are people changing them because the pump(s) actually break or do the lines just clog and people replace them to be ride of the blockage. If you...

I am looking at changing from Mimaki full solvent SS2 ink to either the Triangle JVS or Lyson solvent line. I just bought a bulk ink system for one of my two JV3 printers so will slowly go from mimaki ink to a third party. Can anyone share with me a good source for mimaki ink and triangle ink...

I am a newbie with these printers so excuse me if this question is odd. In my printer I noticed that the ink from the cartridge slot goes through a larger diameter tubing (id 2.8mm or so) and then routes into the body of the printer. About halfway down in the mid section of the printer there is...

Hi my JV3-130SPII was involved in a small traffic accident / fender bender :) The main hinged cover took the hit and its all distorted and the vent fitting was broken off. It looks like a real pain to straighten. Doesn't look like anything else got hurt. I know some people are decommissioning...