Search results

Hello all. I am looking for recommendations on a brand of Calendared vinyl or other material that has a highly aggressive adhesive but also removes cleanly. I tried a few permanent ones, but so far, they have not been "permanent" or left gray stains on the surface. This vinyl will be adhered to...

So, yea this happened today, this machine has been an absolute workhorse for me, but I wasn't paying attention today. Th print head looks fine, and it prints fine. The printer works normally but minus this piece. I am going to look around to see if it's something I could buy. It looks like...

Hi all, I have an issue I have been chasing with GammaPrint that I can't figure out. The issue is present when using flex-cut. I have Summa t-series and a few cutting applications. Gamma, Cutsalot & vinylmaster. The cutter works fine in CutsAlot and VinylMaster, but GammaPrint is a mess...

I have a S40600 that the BK1 nozzles keeps missing the same line. I do a medium cleaning, goes away on the next nozzle check. The next day, do a nozzle check and the same missing line, goes way after the cleaning. Not sure if a daily print head cleaning is recommended or I hurt something, or...

Does anybody here with a summa T140 have issues with freezing and inconsistent cuts? My T140 has frankly been amazing and simultaneously a pain in the ass since I got it. If it fails to read a barcode, it will go to a please wait screen and stay there forever. Pretty much any error gets stuck...

As the title says, I am looking for scraps (larger than 6.5in x 6.5in) of different printable cast vinyl. My shop is moving to cast printing, and buying full rolls to test & play with is a waste. I am having a hard time getting samples for cast media. I am not looking for rolls, just scrap...

Hi all, I have an Epson S40 in the basement of my home, and the basement is going to be remodeled. At the moment, it's partially finished, it's spotless clean with flooring, but it doesn't have any insulation, Drywalls, a ceiling, etc. I have had a few contractors come and make a floor plan...

Hi all, I am looking to upgrade my cutter to something more reliable. I currently have a Prism 28 24 inch cutter. I haven't had any technical issues with it. It always reads the registration marks, and its software is easy to use. However, it's a very clumsy system. The rollers leave a lot...

Hello all, I apologize in advance for such a noobish question, but I am on the verge of buying new equipment, and my confusion is turned up to 11. However, my expectations may be unreasonable. This side of the world is new to me, and I think I have the wrong mindset. I have three Canon...