error

I'm exporting a pile of miscellaneous vector files (clip art etc) from my old Inspire 1.6 software, and importing into CorelDraw 12. Most of the EPS files import perfectly, but some won't import at all, and I get an "Import Error" message as follows: "stackunderflow error reported by the...

Hi everyone!, Today when I started my day at work went up in my Rockhopper 3 printer and gave me the following message A259 Alert System - Hardware not found. Find a colleague you tube with the same problem but does not say whether it has been solved. http://www.youtube.com/watch?v=rPevXiMI8lc...

Hello every one I just signed in and was wondering if some one can help me with a problem that I have with my linx 60 from GCC. I havd this plotter for about 8 years now and been haveing trouble with it it just wont cut, I have been working wit corel draw 12 and cutting from it and WinXP sp3...

Okay I'm all out of ideas here. My plotter no longer wants to cut correctly. When cutting any letter with a curve for some reason it is unable to find the start point to complete the cut. It is generally 1mm off mark left to right. I stress the left to right because if it was as simple a fix...

:helpI have experimented turning the DIP switch SW-8 & 9 from off to on (per Roland's advice). Tried to cancel the error with the setup key. Moved the pinch rollers every-which-way and still cannot shake this pen mode. This has shut me down. Roland says my mainboard is shot another shop says it...

Once a job is sent from Flexi to the plotter it feeds out all of the material and never cuts. It does not stop at the end of the material but rather spits it out. I have cleaned the sensors, checked connections, performed test cuts from the menu, and doe an overall cleaning. Any suggestions?