Help

[Lightbulb88]

Solventinkjet.com is an active trusted member here, so I doubt they'd sell you a used or refurb one. It's quite unlikely you'd get 2 defective heads at once. If you rule out the cables, my guess might be the board those cables go into.

Zoogee World, I was my ribbons, thank you.

 

[Smoke_Jaguar]

Thanks for following up, thread might be useful to others in the future. =)

 

[Lightbulb88]

Thanks for following up, thread might be useful to others in the future. =)

Gotcha!

 

[Lightbulb88]

Hello, I have a roland versacamm sp-300v and I had lost color on one print head, the magenta and yellow side. I replaced the head, cables, cap station, and dampers. I recovered the color. Now I have another issue, when I put things back together, the manifold on the black broke. I purchased another manifold and I didn't get color on the black and cyan head afterwards. I then purchased a new head for that side as well, changed the dampers too. I still have no color on the black side where I did before the manifold broke. I checked the fuse and it was good. I have no idea where to go from here, does anyone have any suggestions?

Thanks,

Lightbulb88

 

[damonCA21]

Did you check the correct fuse? It is the small one mounted on the mainboard, not the ones to the main power supply. If this is ok, also test the transistors. It could also be a bad head carriage board. When you do a head cleaning are you getting black ink coming out into the waste bottle?