rushworks graphics
New Member
we get asked quite abit for round or oval shaped small magnets. the sqaure ones we cut with a standard ruler blade type set up, real easy. the oval/round ones we sub out. however, what would be a good way for us to do it? would the only way to do this be a die cutting machine? if so, what should we be looking at? costs for the machine and anything else involved. are the dies expensive to purchase etc.
or is it a case of these things are quite expensive and were better off just subbing them out still. i know it depends on how many we sell etc. we don't sell thousands and thousands all the time, its usually 500 hundred to 1000 a time seems to be.
i know someone said they were using a plotter just for cutting out magnets, but wouldn't that damage the strips and blade if your constantly cutting out the magnets?!??
or is it a case of these things are quite expensive and were better off just subbing them out still. i know it depends on how many we sell etc. we don't sell thousands and thousands all the time, its usually 500 hundred to 1000 a time seems to be.
i know someone said they were using a plotter just for cutting out magnets, but wouldn't that damage the strips and blade if your constantly cutting out the magnets?!??