Search results

2 amp max fuses to be used. 20 amps is like a bypass with a wire Where did you find the 20 amps? Paco

Use two fuse holders of 5x20 mm and solder them over the curent broken fuse with wires.Easier to change the fuse then. Like I said if you are working on the machine remove the power cable. Does the colorhead prints with bypassed fuse? Paco

Slow down..........learning curve........ I run this baby with the covers off at the righthand side so I can see what happens while the machine is cleaning. Most important with these machines is to keep the lines clean and the sponge in the cappingstation wet but do not store it with strong...

This is the most problematic error I found sofar that is unpredictable. Mostly it has nothing to do with the encoders or the motor or the tension of the belt. With a tiny friction this error can be thrown up. Happens often when it leaves the capping position. Sofar this you can check...

Run machine test print with the four colors. First adjust manually the black compared to the colors in height (horizontal) so they are almost at the same line if they are not. Peanut described about the wedges. In other words you loose up the head and align it and then fix and test print untill...

OK, Are you the first owner of the machine? Did it worked before? Which firmware is in the machine with startup? Paco

Does your rip tell or has told the machine the witdh of 24"? Paco

Did you try lower dpi 720x720? or 360x360? to see if there is an interval too. Paco

If you swap both machines on the rips what happens, this is not a machine problem. Paco

All the 4 machines run from same rip station? It looks inkflow on the printout is starving but if it Always happens at the same spot then it is rip or electronic related. If print is 1 meter cyan and then other color and problem happens? If print is 50 cm cyan and then other color and problen...

These sponges will not fit DX2 head machines. Paco

USB or Paralleport dongle? If USB put it in a free USB port preferabele at the rear side on te motherboard. Then instal the CD? Disks. It should recognize the dongel and free up the RIP program. Paco

Did you cheked fuses on main board. Is it only black or the whole head that also contains black

If the seller can not show testprint without missing nozzles dont buy it. If it does not include a rip 1500 is to much. Paco

I dont know mutoh cutters but if the cutter also reads the reflective vinyl while loading you might need to fool it with white too for this! Your cover up with black on white regmarks should work if the machine is not geting an error on the loading. Paco

If you need to be sure striking is the issue. Print with the head raised if there are two settings for it. If it does not with the head raised for thicker banner material then you knwo the cause for sure. Paco

Weird, then it must be something in flexisettings. I use network to parallel port box. So no idea what the correct setting must be for parallel port only, It must be simple. Paco

mechanical print head alignment, see service manual.

Nozzletest still working?

You printed one photo, so does that mean there was ink on the media that time? The more specific you are in problem description the sooner we can attack the problem. Have you seen the machine printing by a RIP. FLexi should work with direct parallel cable if settings are OK and if the machine...