Search results

The ALPHA Matte Photo Paper - 8 mil, matte photo paper Water and scratch resistant Special coating provides block out and eliminate cockling For any photo reproduction Solvent/eco-solvent, UV and latex ink compatible Can be laminated we get bidirectional wrinkles at 16p with minimum...

I've got a client wanting to know if he can/should varnish over signgold lettering I'm applying to his boat.

Tommy did you ever figure this out? I have been having the same trouble all of a sudden. I've been resorting to that and cutting laminated material without issue. The other day though I printed material I hadn't laminated (laminating reverses the material direction) and the job cut upside...

I have to affix a 2"x5" aluminum plate to a concrete pedestal (see below) I was thinking about just putting down a tape mask and then coating the area with silicone, scratching up the back of the plate and sticking it on. How should I be installing it ? Thanks!

So do you know if 3M 3662 with their floor lam would be good? I won't be able to make the lam oversize though as I would be ordering it from 365

Thanks Bill - I found someone who will do me a 21" x 21" thin sheet of laser etched metal that will look great for the dedication.

I'm deep in it on this one. I've got a client having their building dedication May 20th with a commemorative plaque, and due to me not understanding Gemini's quote I did not understand that they had inverted the layout until I got the proof yesterday. Now they say I need to go bigger, change...

I'm not sure what size these are and what software you're using but CorelDraw has a Corners tool that lets you set a radius as small as .01" and rounds your sharp corners. It's not perfect but it usually only chokes if there's two nodes right on top of each other. I put a radius on just about...

Our local Fire Dept has round black vinyl tables in their lounge area that are going to be used for eating. They want an 18" round "In Memory of" graphic in the center of each. I don't think decals would be a good long term solution with the grain of the surface plus the wear and cleaning...

Thanks y'all!

We had a bunch of Yeti tumblers engraved. Most looked great but a few came back like this - The rest are as shiny as that little scratch in the forehead (ahem...) I'm thinking the lettering might be passable if I could get the main parts of the bird shining. Anybody had to fix something like this?

Bill are you saying you feel that silicone on the stud in the 5/8" decking would be sufficient to hold these? I'm thinking that if I used these, since these are only 14" letters, I'd probably just need one of these on the top and another on the bottom, and the rest of the studs could just have...

Like this

Yeah oops!! It's not R or PBR - it's horizontal! Those are side views

I cannot get to the other side. It's new construction but nobody thought about the lettering until the nth hour so there's drywall up inside. Do I need to tell them they either need to open the drywall up or we need to use rails? I've done plenty of acrylic or plastic lettering with just a...

Just to clarify, are you asking what 49Pppl means? (and just to clarify, I have no idea what 49Pppl means, never seen anything like it)

I'm not sure which is the lesser of too weevils - I'm installing 14" stainless fabricated letters w/ closed backs 1" deep plus 2" spacing. Putting the studs in the valleys seems like it makes more sense, but will it make the drill template much harder to use? Drilling on the peaks I just need...

I just told Wensco I had a bad roll and they replaced it without so much as a blink. To clarify, I am having no issues on any other rolls of materials.

Thanks for the quick reply!

I ordered some photography lighting stands from amazon without paying much attention - when I got them they were "Amazon Basics" brand I thought if they're shoving their way into something as niche as lighting stands—everybody's fucked.