Search results

Should be no problem replacing just the broken part as long as you have the correct replacement tubing.

Try to be specific, Onyx print and cut workflow is quite complicated, tell us what is the problem. Which part of the workflow is not working? You may find the solution at Onyx Support Center(click on the link below), you need to register if you are not yet a member, you can then do a search...

Try loading a sheet instead then re-do the PF Calibration and see if you get the same result. A sheet will rule out media supply or take-up unit issues if there is one installed on the printer.

This is more likely a faulty heater relay board.

In the user menu, set Spitting to Origin instead of On Media

Your printhead could be faulty and is causing the fuse to blow, possibly needs replacing at this stage.

Automatic cleaning by selecting Headwash or Longstore Menu on the printer's control panel? NO, you will need 4 cartridges in one go. Manual cleaning using a syringe? YES

Both printers use the same printhead, the main difference between these 2 printers is carriage speed (firmware) and the ink cartridge bays (horizontal vs vertical)

Inserting the cable with reverse pinouts can easily damage the mainboard.

Yes, Randy is correct

This is usually not an issue with Mutoh Eco Solvent Ink but it is still a good practice to flush your waste ink lines periodically to avoid this problem. Enter the CR Maintenance mode, when the printhead has moved away from the maintenance unit, simply squirt some wash solution on the cap unit...

Depending on the RIP you are using, most of these settings are overridden by the program so there is no need to worry about them, except possibly the PF Adjust. In my opinion, this is the only setting you really have to be concerned about. Since different materials, example Vinyl and Banner...

If and when I have to do what you are trying to do, I have to upload the .ulk file from the printer concerned using MSA, then email the file to Mutoh for updating. It will be emailed back to me and I will then install it to the printer.

Sorry, have not seen that error message before. You have 2 identical printers, correct? I suggest you swap components one at a time until you determine which part is faulty.

No problem, glad to be of help.

Switch off the printer. Simultaneously press and hold down the Left Arrow key [< ], Right Arrow Key [>] , and the Down key [-], switch on the printer. Keep pressing these 3 buttons until Maintenance Menu is displayed on the Control Panel.

Ink on the printhead is not being replenished properly so it heats up, other than that, head is on the way out

Looks like damaged head to me, that much ink dropping could mean sealing membrane is broken so ink is leaking through the sides of the head.

Check that the ribbon cable connecting the control panel and the manboard is properly inserted on both ends

I believe that information is only given to authorised Mutoh technicians.