Search results

Myriad Pro SemiBold (stretched) would also work.

The pressure is only going to do one of a couple things to cause a change in the machine: - Apply pressure to a pressure switch or put tension on a cable/belt. - Move a "vision" sensor to another location so that it sees what it likes/doesn't like. - A wire could also be broken/loose on the head...

Have them take it by Maaco and get a cheapo paint job that is similar to the wrap color. That'll get you a better finish to stick to. We have wrapped a lot of them with solid color 1080 and 180c w/o issues. Just make sure they're clean, but YMMV as I'm sure the paints used vary from truck to...

Looks good to me, can you make it edge-printable instead of solvent?

Or are you maxed out on height? I would suggest putting a box around all the artwork, but your 4-corner boxes seem to show there is another issue. I'm betting somewhere the artwork has an error in it, and that is confusing the machine. I assume there is a stray point somewhere causing the issue.

Check craigslist, there seems to be some appearing on there every now and then. I know I've bought them off there before. ;) I would say my Edge 2 has had significant usage, and it says it currently has 37,367 minutes on it. Does the counter roll over? Does it also come with software, and a...

sounds like electrical. possibly the ribbon cable or slider board. All the other test prints are confusing me, can you do another print and have only it in the picture and take a better photo? Why was the head replaced?

Once you get the old strip out and lay them side by side it should be self explanatory. The strip tension is held by a spring, so if it is a hair different size it should be just fine. Use the exacto like a drill IIRC (spin it with your fingers). The sensor doesn't read all the way to either...

post a photo of the print.

what type of floor? how long are they going to be down?

http://www.signs101.com/forums/showthread.php?111401-Changing-Encoder-Strip-On-SP540V Looks like the Merchant Member SolventInkjet.com has a generic one for $89.00.

IIRC I bought a genuine Roland part encoder strip for right around $120 back in the day... I think we bought all of our parts from Nazdar. Shouldn't be anywhere near the price you're looking at.

You can also flip the encoder strip upside down and use that portion if the top is damaged or stained beyond repair. I think you have to cut a new little hole with an exacto but it should be easy enough, it's been 6 or so years since I've had to do this.

We use Onyx rip and it is a feature in there.

Be careful posting pics like that online possibly w/o proper safety gear on. You may want to remove or blur that area.

Select all your shapes and choose "Combine On". (the little blue donut, also the "0" key)

Looks 1000% better!

Those are printed on a Gerber Edge. We make them here, but I am not a Merchant Member.

Clean the strip again. Cleaning the sensor isn't all that hard either. If it aint put back in the right spot you should be able to tell or adjust it easily. Lube the carriage rails also with 3-in-1 oil.

What software are you using to output? My Omega 4.0 has a driver for it, our Mimaki plotters here are ran by Onyx most of the time.