Search results

Thanks in advance.

In Versaworks, under printer controls, there's a drop box under feed calibrations controls, you can change it to use printer settings. The adjustment is made at the printer though like everyone else said, menu > calibration > test print, pick the value with no gap or overlap and select and enter...

better picture of the bottom

close but not it

I'm struggling to figure out these fonts.. the laundry list at the bottom is pretty close to helvetica medium condensed and or close to Din ... and the part in the red circle is close to garamond bold. any help on these would be appreciated.

It works fine, transfer tape doesn't stick to backer is the only issue or could be the only issue if not careful.

roughly 9" per wrap

it's not beansprout but close...

Tried whatfontis and identifont with no luck.

could quite get an exact match.

Haha I love when I hear people upset that we pulled out of the Paris deal... if you really cared you would agree with pulling out of the deal that doesn't require China to reduce emissions and lets Russia increase its greenhouse emissions 150%.

This is exactly what I'm looking for, is there and decals with the manufacturers name on yours?

Probably have a couple of cables crossed

I don't see how this could work... once the ladders are spread far enough apart to get a tractor between them, and get the board up 7' or 8' in the air it seems like 13' would just barely reach the inside rungs. Does the board lock onto the runs or just sit on them?

red bag... $18 is cheap insurance

Did you reload the job in your rip before reprinting? If so then it was most likely something you did, maybe switched to rgb mode in your drawing program when you where in cmyk the first time or visversa.

Pretty slick how did you make the spring loaded holders?

Anyone try the led stand offs such as the ones Outwater sells, if so how did they work?

I think we have landed on one of each everything the same except the "all". Also we will be doing the lettering for the name, phone number and website in reflective. Also we will probably mount the reflective "all'' to wrap vinyl before cutting so we can remove it easily and replace without...

Thanks for all the replies, we are still on the fence. The consensus seems to be everyone likes the blue better but would go with red cause it's already in use. We may just do one of each not sure, I changed up the red layout with grey "circuits" which seems to help it stand out more. Would...