Search results

Might be an option, sounds expensive though.

My experience with Rapid Remover is that I have used it on old vinyl before, but didn't do much to the vinyl itself, just aided in the removal of the leftover adhesive. The top layer of old vinyl had to be scraped away first, which usually just flakes away from the adhesive. I am hope to cut...

Sorry guys, hectic day here... forgot the particulars. These are glass windows. Two are sized at 103" x 43" and the other at 91" x 43". So fairly large. I'm not sure if a vinyl zapper would damage the glass or not. Have not really used one before. I figured just old fashioned elbow grease...

I have a job coming up that needs the removal of old graphics. This vinyl appears have have been on for at least 7-10 years. It is baked on and cracking. Any suggestions of the quickest and easiest way to remove? Thanks in advance. Attached are photos.

I've done the same. I NEVER hit "get media width". I've noticed this will make all cut lines offset. I learned the hard way on a 6 foot trailer graphic printed on Oracal 3951RA laminated with Oragaurd 290. Expensive mistake!:banghead:

Although handing out a CD portfolio is a great tool for potential customers, have you thought about a website? Whether you are looking for an elaborate or simple website to promote your work, there are plenty of free portfolio host sites that allow you to upload some of your work for free or...

Thanks for the info. Any suggestions on where to start on such a large panel? Best to hinge in the center and squeegee one side to the right, then to the left? Or just start on one end and squeegee to the other, hoping the panel will end up straight?

I'm getting ready to install some graphics onto a flat box truck, no rivets on the sides, a few on the back around hinges.. I have a 13' x 2' panel (see attached thumb, highlighted in green) I would like to install in one piece. I have printed on Oracal 3951RA and used 290 cast overlam...

I've noticed the Color Management preset in VersaWorks RIP Software can have effects on grays/colors as well. I normally print on Pre-Press U.S. versus say Max-Density U.S. The colors print more like how I see them on screen. I've notice grays looking greenish if I print using Max-Density...

I'm looking for the profile for 13 oz vyjet banner material for the aforementioned printer. I have been unable to find one anywhere, or even from Fellers where I ordered it. Does anyone use this material on this printer. If so, where do I find the profile for it or one the will work just fine...

Our shop just bought the Roland soljet III xc540 and was curious about this myself. Wouldn't think I would trust this on a vehicle wrap. I'd assume it would be difficult to wrap without an overlaminate and the cost is too expensive to risk the chance of redoing it for an unhappy customer...

Our shop just received a Seal 54 Base Heat Assist Laminator and I am just learning to use it. It's a pretty basic laminator that's very easy to use. I am trying to use the Heat Assist function. The manual says to allow ample time for the Upper roller to heat up to 40C before using. I've had...