Search results

Are there any ink channels reporting as expired? You can find this information at the printer front panel, under the ink icon. If there are expired inks in the printer, you'll want to get them replaced with fresh ink.

Give it a shot - and be sure to share your findings with the board!

https://www.printos.com/ml/#/medialocator Probably 3M IJ680CR-10. It's listed as profiled on the Media Locator.

https://variableinc.com/compare.html

X-Rite recommends annual re-certifications of the i1 Pro spectrophotometer measurement instrument. Not sure how many users actually follow through on that guidance.

Any update on this?

Here you go!

Yes, there are electronic ink sensors for each ink channel, located at the cartridge interface. Monitoring things like ink levels (as well as the amount of media remaining on the roll) can be done at the printer front panel, remotely on the computers on the local area network, or even more...

Many users of HP Latex printers drive the cartridges completely empty. When an ink color goes to 0, the user has about 30 minutes to replace the ink cartridge and the job will pick up and continue, in the vast majority of cases without any visible defects. If the inks are not replaced within...

Is this for ASTM Regulatory Traffic Signage, using 3M traffic and safety sheeting films, such as high intensity prismatic 3930 or diamond grade 4000 series? Does your Mimaki eco-solvent have the ability to produce regulated traffic signage?

Not sure how this could work, as this media has a removable film on it's face which is intended to be removed only after installation is complete.

Combination of research and a guess...

Post a pic of the Test Print: From the front panel on the printer: Settings > Image Quality Maintenance > Clean Printheads > Test Print Just a guess that one or more channels are not jetting ink (perhaps lc on printhead 2?)

It's now been a week since the original post. Any status update?

For a projection application such as you are describing, a high ink load would be necessary. I would probably begin tests with the media preset shown in the attachment as it has a high ink density of 185 percent. If you need to reduce the temperature, compensate with increased Inter-Pass Delay...

What is the application that you would be using this non-adhesive clear polyester film for?

Device drift will become apparent in neutrals (grays and pastels) way before ever being visible in saturated hues.

Make sure that all four pinch rollers are being in placed in contact on the print media (or all three on the Basic cutter). If one is set off the media, you will get this type of result. You can also check the imprint of the grit roller track on the back side of the vinyl (in the paper release...

It is likely that the media print surface is contaminated. To test this, clean a defined area with Isopropyl Alcohol and a towel, and mark the cleaned area with a sharpie marking pen. Next, print a job that extends through the cleaned area well into the non-cleaned area. After printing, inspect...

Maintenance Cart counts down from 100-percent. SMKs count up to 100-percent