Search results

looks like you are etching at too high of a power. Try one pass high power to burn the backing off, then a lower power higher speed run with the air cone on the end of the laser. You could also burn at a higher resolution for eliminate the banding. Try source files that are 300 dpi

installed.

Here is our latest. Our last two blog posts show additional pics. Carved 30lb Precision Board plus. Vines are epoxy clay from Smooth on. Paint is Sherwin Williams and Modern Masters. http://www.synergysign.com/a-room-fit-for-a-princess-pt-2/

we recommend soap and water cleaning. Windex is the worst thing you could ever use on it. In any failures we have had in the past 3 things usually cause it. 1) Not rolling a print laminate side out 2) cleaning with windex 3) too much tension on the laminator when applying. It stresses and...

We are using a powermatic 3phase setup w/ the throw away bags. http://www.woodcraft.com/Product/849663/PM1900TX-CK3-TurboCone-DC.aspx?gclid=CJLPm-bu48wCFRIoaQoduy0Hmg Its al lot like the one in the link, but ours flows 2600 cfm

Thanks for the comments. This was an extremely fun and rewarding project.

We went futuristic this time. Visit the link below for full write up on our blog. http://www.synergysign.com/blog/?p=476

We subbed the eps part out, but from the build pics, it looked like it was cut with a hot wire and the pieces glued together. We built a scale model then had them build the 48" version. Had to be super light for the car roof.

customer wanted a font that looked " like " the smart car logo. Also wanted it to look branded into the bun....

Precision Board HDU: Meeting Green Signage StandardsDecember 10, 2013|News Did you know that because Precision Board Plus is certified green, and assists in meeting LEED requirements for obtaining USGBC and ICC 700-2008 building credits? Today’s architects and business/housing planners place...

LOL @ a conservation group insisting you use wood on signs.....

nerd tape because the theme was smart and the customer chose to convey it with glasses and nerd tape. I think it works very well. We added the ketchup and mustard today. A little bit more paint and we are all set. The wiener was carved from eps foam and hard coated. There is an aluminum...

This was a fun one..... :ROFLMAO:

Check out Lord adhesives / epoxies. They have the perfect stuff.

We print on raw maple plywood all the time. Nothing rough saw or warped though...

We bought ours. It was a steal because we took a huge risk on a run down property. It paid off big time though.... Zero EPA studies and Zero issues with the bank. I've heard horror stories though.

Do you think you have what it takes? Here is the online form to apply for entrance into The Sign Invitational 2017. http://thesigninvitational.com/apply

We have a winner. Check out the event results here!!! http://thesigninvitational.com/congratulations-to-peter-poanessa-the-2016-sign-invitational-winner

I'll over build every time. Way cheaper to spend it on steel than to make a new one when it cracks in half.

I don't want to hijack the thread, but here is how that turned out.