Search results

The walls were painted with Sherwin Williams promar 200 6 months ago. All tests stuck well with a stronger adhesion then the usual 40c we’ve been using for years on these same walls. This paint has none of the usual additives like silicone.

Has anyone used Lexjet Print N’ Stick? We’ve been using it and it bubbles and channels the next day when we installed a big project on some 16’ walls. It seems to be fixed with a heat gun and squeegee. Has anyone dealt with this?

Do you think a heat gun can correct the bubbles and help it stick better?

Every time I install Phototex on large walls I get bubbles and channels that appear after installation. I push them down and you come back. The only way I’ve fixed it is with a little wallpaper paste in the area. Any suggestions on what to do to fix this? Could I be installing this wrong?

I ended up solving the problem! Someone on the FB HP forum told me to delete the HP PVC Free wallpaper icc. Apparently that was the problem! The printer connected no problem after that. I’m irritated that hp supports only advice was to replace all the print heads and inks.

I believe I have nex i believe it nexus_02_14_00 I just uninstalled and reinstalled flexi and did the hard disk recovery and no luck.

I deleted all downloaded icc profiles and uninstalled the printer from flexi. When I go to reinstall as it’s loading about half way I hear a ding from my printer and the error 79:04 pops up. I can’t even get to the point of printing anymore.

Yes. I did Service Menu>Service Utilities>Hard Disk Recovery>Unsecured Hard Disk Erase. It still gives me the 79:04 error when I try to reconnect and print.

What can I do to fix this problem? I’ve tried downgrading firmware. However, the last firmware update I had was in 2015 and I can’t find that. I’ve tried a hard reset but it doesn’t seem to do anything.

Does anyone have recommendations on a place to buy replacement parts for HP Latex printers? I have a L110 and I may have to replace a hard drive and I know it needs a new carriage belt as well.

The link light is still on and when i type the ip address into my browser the printer comes up and is connected.

Where do i find that?

I’m in the service many and this is what I get. Where’s 1.11?

Yes I’ve done all of that.

This might be a stupid question but what are the steps to find the hard disk recovery in the service menu? I can’t seem to find it.

I just updated my HP Latex 110 firmware and now I’m getting a 79:04 error and it’s not connecting to the rip software anymore. Has anyone had this problem and fixed it?

Does this apply for a L365 too?

I’m not sure it is possible to do unidirectional printing on a 110 just bidirectional. I’ve tried a lot to make our printers print good quality prints and it dose but nothing close to an epson. If you have additional advice let me know.

I’ve definitely lost jobs/ didn’t have repeat jobs due to grainy prints. However it only seemed to be when we did fine art stickers (stickers for artists/ graphic designers). Those who want label or promotional stickers for a business have not said anything and have come back. I think if we had...