Search results

laird plastics

second side profile resolves almost all of the issue. less vacuum is key. The vacuum on the printer has zero affect at holding down the ACM. The weight of the material does all of that for you. As far as "better options" Only the Swiss Q has a better IQ than the HP Latex flatbed printer. Every...

Mmm the printer needs to be online and ready “media loaded” for it to do its purge through the night. If it is left in a not printing state the auto cleaning won’t work. No reason to leave media bar up. Leave printer loaded lever down… Only on a vinyl cutter do you need to release the pressure...

White is meant for under flood, over flood and spot. It was not meant for color white color on the s80. I know it was selectable on the s80 but I believe Epson removed from s80 The white ink is not opaque enough to cover

was there curl to your laminated vinyl before install? maybe too much tension when laminating.

there's nothing bad to say about this printer. Epson sure colors have the best IQ at this price. This is a single head 4/c and will be great for everything you throw at it. We added a second for everyday use. They run in 4/p all the time. I would upgrade to a full version of onyx when you get a...

Ahh s70 the original 30 50 70 were prone to this if your R2R has not been calibrated properly. Most times they were not. It does not show on all media, but this might be one of them. Other item to check is the media profile that you created on the printer. You probably need a specific one due to...

What media? What heater settings? If media is older, wipe area with alcohol, mark with sharpie and print see if the cleaned area prints better. If so bag the roll for a new one. If temps of profile are set high, and printing in a cooler room, the heaters may not be keeping up with prepping...

So RGB is a larger color space and what we use to view images on a monitor…millions of colors. Printing is done through cmyk, mixing colors to make thousands of colors. Do all of your design in rgb. Give your rip the most possible colors. It will convert to cmyk and give you the widest gamut...

I would not splice this. The weight will probably cause it to fail. Just outsource it.

Sounds like your safety sensor or your pressure sensor. You should find a tech and have him perform a pm service. Make sure they have magnetic pressure gauges.

Fantastic

If your edges are curling you have too much tension when laminating…less is more. If you can laminate with zero tension, it would be ideal

I just put in a 30F it is a monster

It’s a 10k printer best bang for the buck. You will be fine

If you are looking for color consistency and panel to panel line up the Epson sure color is the way to go. The s40 is the best bang for the buck. I love HP. The iq is better on 300 series than the 700-800. There are a lot of people working through issues with their printers. HP will fix them but...

You are

You are going to hate canon

Possible blade not installed correctly in carriage. There is a calibration you can do as well.

Colex can recognize edges of board…do some digging in the manual for set up.