Search results

Welcome from your neighbor in South Omaha!

I think I'm going to put a decal of a guy in a Roland shirt peeing on Mimaki on the front cover of all my Rolands.

:roflmao:

Wait for windows 8 in the fall.

My current job requires us to use the auto-retract knifes. I absolutely hate them. For the average production employee who only uses knifes to open packages they're fine, but for a technician like myself that uses them for a variety of things not as simple as cutting tape they're a pain in my...

We print on magnet all the time without issue. Set head height to high, adjust feed calibration, and get your blade depth/pressure set and let it run.

Happy Birthday!

Awesome! I wonder what ads from today they'll be laughing at in 50-100 years.

Omaha has one of the best economies in the country and if I never watched/read any news I would have never known we were in a rescission. That being said I have watched/read the news along with every other person and have been taking this opportunity to blame any and everything that goes wrong...

Make sure your sheet cut blade assembly isn't broken or hanging too low. Roland sells a tool to check the belt tension, before I bought that I would inspect the pulleys and make sure all set screws are tight. I would also grease the entire belt with silicone lubricant. Also I would try turning...

If black still streaks when it is connected to the yellow cable I would say you have a bad head.

Its one of three things: 1. cables (either bad or not connected correctly) 2. print head 3. head board The fact that you say it blew fuses makes me think it is the head board and/or head. We've had the exact same thing happen where a head went bad and caused a component on the head board to go...

Not if there is no air in the bag. If its a sealed bag with only ink in it, then all you can get out of it is ink. If you pierce the bag and introduce air that's when you'd have a problem.

When it comes to hiring somebody its the same as anything else... you get what you pay for. The problem isn't the good employee has no loyalty and leaves, its the fact that he/she is not getting paid enough to stay.

Once you pierce a bag and try to use it you will get air in the lines. Think about where the needle on the machine goes into the bag. If there is air in the bag then as soon as the ink level drops below the spot where the needle enters the bag you will be sucking air into your machine.

There was one time when I had a magenta print head that was going bad (banding) but would still print. So knowing that yellow is much more forgiving in the prints than magenta (at least in my experience), and the fact that I didn't have the parts on hand needed to fix it I swapped the 2 heads. I...

According to the article I read it was bath salts and bath salts are banned in 37 states. Whats been happening is they ban a certain chemical that's in the bath salts then chemists slightly change the chemical into something else and voila its legal to sell again for a few months/years then the...

never mind

I've been on a forum were you could give "thanks" to people for good posts. This made it so you could be positive but not negative.

If you do ship it make sure you get it insured. It will cost a little more but it will be worth being worry free.