Search results

Is anybody out here direct printing on carpet? If so, can you shed some insight to me? (what carpet do you recommend, what printer has worked for you, what were the results?)

We use MPC Plastic Prep 6428sp. We use it on anything we run through our FB700.

Have you checked the actual temps with an IR temp sensor? My heat/cure elements went out and didn't code in the machine. We replaced them and have been good since then.

We used the 290GF here for years. It was great not having to worry about a colour shift after lamination.

I know this is an old thread, but did you find a resolution to this issue? My 9000 just developed the same issue.

We have two HP9000s (Colorpainter 64) and really like them. I ran a M-64 for a day at a local retailer in Charlotte and enjoyed the machine and the print quality. It's like my 9000 on steroids.

We use Lexjet Sunset Satin 300gsm here. Just upgraded from the 9000 to the 9400.

We solvent print, then laminate with 3M 8518 or Oracal 290gf here. You must let it outgas 24 - 48 hours. We have had outgassing when laminating too quickly.

We have had the same issue here. Heat has always taken it away. Sometimes it has taken heat & time.

I have had this happen on my L26500. I have found 2 issues. The non locked hub on the media feed is not holding the media tight and the tension assembly on the media feed is not having a good moment. I have been able to clean the hub and the tube to reduce that issue. On the tension...

My solution is to ditch the latex and purchase a Seiko. Don't have to change any print heads.

Windows 7 takes a different driver for the HP9000. Onyx has a driver written for the windows 7 for the printer to work. Not sure about Wasach.

I agree with all the above mentioned comments...Good Job everybody. :thumb:

I have my Delorean ready to go!!!!

Yes. Next to the power for the battery back up.

I have had it with a FB700. We had to adjust ours. I think we ended up at a 1/4 turn.

At this time there is no ij180c, ij180cv2, or ij180cv3-20 available. Ask your 3M representative for an answer. I've been trying to get some for years. 3M looks at me like I have 3 heads.

Casey, I think that would cause major earthquakes with potential for hurricanes.

What do you do when your 6TB NAS drive is full? The cloud just keeps raining.

If the heads aren't firing, but getting ink, power down the machine and check the cables at the head. If they aren't getting ink, check the lines. I used to keep O-rings for all the connectors. They are bad about air leaking if jostled.